Installation guide

3-62
container Commands
Examples
Before renumbering an array, use the container list
command to obtain information about any existing arrays. As the
following example shows, there is an array 0 (a volume set) on this
controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 20.0MB NTFS 0:02:0 64.0KB: 10.0MB
0:03:0 64.0KB: 10.0MB
The following example renumbers array 0 to array 5:
AAC0>container move 0 5
Executing: container move 0 5
Use the container list command after using the container
move
command to display information about the array you just
renumbered, as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 5 Volume 20.0MB NTFS 0:02:0 64.0KB: 10.0MB
0:03:0 64.0KB: 10.0MB
As a result of renumbering array 0 to array 5 with the container
move
command, the Num Label column displays ID number 5
instead of 0. This column also displays the label assigned to the
array when the array was created. If no label was assigned to the
array then no label appears in the column.
Related Commands
container commands:
■ container list (page 3-50)