Specifications

18
19
Updates and Settings
Firmware updates and setting changes can be performed with
the included USB Cable and a computer connected to the
internet. It is important to disconnect all power from the system
before plugging into the computer. Go to www.AdaptivTech.com
for software downloads and detailed instructions.
Warning: Disconnect all power from the TPX™ Laser
Jammer System before connecting to a computer.
TROUBLESHOOTING
If your TPX™ Laser Jammer System is not operating properly,
please refer to the following guide:
MAINTENANCE AND CARE
• The TPX™ Laser Jammer System is weather resistant. It is
designed to withstand temporary exposure to moisture, such
as rain or fog. However, it should not be exposed to moisture
for a prolonged period of time. Do not leave the system out
in the rain when not in use. Do not hose the system down. Do
not submerge the system as this will void the warranty.
• Clean the system components with a damp lint-free cloth only.
Do not use any chemicals as they may attack the plastic.
• Dry the system components with a lint-free cloth after it has
been exposed to moisture.
• Keep the Transponder lens clean to maintain optimal
function. The Transponder strength may decrease if the
lens becomes scratched. The lens is easily replaced and is
available for purchase separately.
Problem Possible Causes Possible Solutions
System alerts
one minute after
initial laser signal
detection
Normal operation
This feature is normal and alerts
the user that the system has
reactivated itself after the pre-
determined shut down period
TPX™ Radar
Detector displays
laser alert when
bike is turned off
TPX™ Radar Detector is
not connected to switched
power source
Connect TPX™ Radar Detector
to switched power source that
turns on/off with ignition
Problem Possible Causes Possible Solutions
System will not
turn on
System not properly
connected to power source
Vehicle not turned on
System power off
Check fuse, replace with a 2A
fuse if necessary
Check power connections
Turn vehicle on
Press and hold button for 2
seconds with vehicle on
System does not
operate properly
Firmware update interrupted
Visit our support site at:
www.AdaptivTech.com
to download software repair
System drains
motorcycle’s
battery over time
System is not connected to
switched power source
Connect power to switched
power source that turns on/off
with ignition.
System resets
when vehicle
goes over a bump
Poor electrical connection Check power connections
System did not
register a signal
when driving past
a police vehicle
Police laser is not turned on
Police laser is not pointed
directly at your vehicle
Non-laser detection methods
are being used
Slow down and remain
cautious