Specifications

8
9
USING THE TPX™ MOTORCYCLE
LASER JAMMER SYSTEM
INSTALLATION
Warning: Installation of the TPX™ Motorcycle Laser
Jammer System should be performed by a qualified
technician. Improper installation may interfere with the
safety and proper operation of the product and/or vehicle.
MOUNTING THE TRANSPONDER
The TPX™ Laser Jammer System includes one Transponder for
mounting on the front of the bike. An additional Transponder for
rear protection is available separately.
Choose an appropriate location on the bike to mount the
Transponder. The ideal location is usually on the fairing, under
the front headlight. The Transponder will need to be mounted
parallel to the road with a clear line of sight straight ahead. Use
the included Hardware and Hinge Brackets to loosely secure the
Transponder as shown in Figures 2a and 2b.
Figure 2a
Figure 2b
Warning: Use only the M4 x 12mm Screws to secure the
Hinge Brackets to the Transponder. Any other screws will
damage the Transponder and void the warranty.
Warning: The 18-8 x 5/8" Self Drilling Screws and
#8 Lock Washers are included for your convenience.
They will work on most motorcycles. However, all
motorcycles are different and it is your responsibility to
determine the best method of securing the system to
your bike. Adaptiv Technologies, LLC is not responsible
for any vehicle damage resulting from improper mounting.
With the Spirit Level inserted into either hole, adjust the
Transponder until it is parallel to the ground. It is recommended
to have someone sit on the motorcycle to simulate the
motorcycle’s actual riding position while this adjustment is being
performed. Tighten all Screws when Transponder is level.
After Transponder is secured, remove Spirit Level and insert
Hole Plugs as shown in Figure 3.
Figure 3
8-18 x 5/8 Self Drilling Screw
8-18 x 5/8" Self Drilling Screw
Spirit Level
M4 x 12mm Screw
M4 x 12mm Screw
Transponder
Bracket
Bracket
#8 Lockwasher
#8 Lockwasher
Hole Plug