Specifications

12
13
MOUNTING THE CONTROL SWITCH
• Determine an appropriate location for mounting the Control
Switch. The best location is one that is easily accessible
while riding.
• Clean the chosen mounting surface on the motorcycle with
mild soap and water. Rinse with water to remove all traces
of soap.
• Once the surface is clean and dry, remove the liner of the
Double-Sided Adhesive Tape and apply the Control Switch
to the chosen mounting surface on the motorcycle with
firm pressure.
• Allow to sit overnight while tape increases bond strength.
WIRING THE TPX™ LASER
JAMMER SYSTEM
General
Refer to Figure 6 for wiring diagram.
Secure all loose wires with included cable ties.
Leave caps on all connectors when not in use.
Figure 6
Visual Alert
Interface Box
Switch
Transponder
+
12V Switched Power
(14-18 Ga)
T-Tap
VISUAL
2A Fuse
SWITCH
JAMMER
LASER
AUX OUT
(3.5mm Mono)
USB Cable
USB
Transponder
(optional)
to TPX Radar Detector
(optional)
GROUND
JAMMER
Computer