Specifications

14
15
Power
To provide power to the system, connect the red (+) terminal
cable to a 12V, 14Ga-18Ga switched power wire with the
included T-Tap. Connect the black (Ground) cable to a ground.
Warning: If the system is not connected to a 12V power
source that is switched off when the ignition is turned
off, it will continue to draw a small amount of power and
could drain the bike’s battery and/or function improperly.
The TPX™ Laser Jammer System is designed to be
powered by a switched 12V power source. If the
motorcycle’s power output is not 12V, a voltage adaptor
is required.
If you are pairing the TPX™ Motorcycle Laser Jammer System
with the TPX™ Motorcycle Radar and Laser Detection System,
the Radar Detection System must be powered from a SWITCHED
power source. To achieve this, replace the Slotted Ring Terminal
on the positive wire (red) of the Radar Detection System Wiring
Harness with the included Male Quick Disconnect. Use the
included T-Tap to splice into a 14Ga-18Ga switched power wire.
Then connect the Male Quick Disconnect to the T-Tap.
If the TPX™ Motorcycle Radar and Laser Detection
System is not powered from a switched power source, it
may display false alerts when powering down the bike.
Transponder
Connect the Transponder to either one of the connectors labeled
“Jammer”.
If a second (optional) Transponder is used, connect it to the
other connector labeled “Jammer”.
Visual Alert
Connect the Visual Alert to the connector labeled “Visual”.
Control Switch
Connect the Control Switch to the connector labeled “Switch”.
AUX Out
The connector labeled “AUX Out” provides an audio output
signal. This audio signal can be utilized with any number of
communication systems. The connector is a 3.5mm female mono
jack. Contact your communication system manufacturer for
appropriate adapter device.
Laser
Connect the “Laser” output to the “Laser” input on the TPX™
Radar and Laser Detection System’s Wiring Harness if you are
using both systems.
USB
When updating the firmware and changing settings, use the
included USB cable to connect to a computer.