Specifications

16
17
OPERATION
Power
Press and hold the button for two seconds to turn the system
on. On startup, the Visual Alert will flash three times and the
audio (if installed) will beep three times. Either the or
indicator will be illuminated when the system is on.
Press and release the button to turn the system off.
Brightness and Volume Control
Press and hold the button for two seconds to toggle between
Brightness Mode and Volume Mode.
In Brightness Mode, the indicator will be illuminated.
Pressing the button in this mode scrolls through 5 levels of
Visual Alert brightness.
Warning: The flashing LEDs of the Visual Alert can be
extremely bright, especially at night time. It can be
distracting and dangerous if you are not familiar the
brightness level. Before riding with the Visual Alert,
especially at night, take the time to familiarize yourself
with the system in a safe, controlled setting.
In Volume Mode, the indicator will be illuminated. Pressing
the button in this mode scrolls through 5 levels of volume
through the AUX Out cable.
The system will retain the last volume and brightness settings
each time the power is reset.
Laser Signal Detection and Jamming
When the Transponder detects an incoming laser signal, it
instantly sends out a jamming signal to prevent a speed reading
on the laser gun. The Visual Alert will notify you of this signal, as
will an alarm signal through the AUX Out (if connected).
With the factory default settings, the system will sense, alert,
and jam any incoming laser signals for 7 seconds after the initial
signal. After 7 seconds, the system will shut down its jamming
and alerts for 1 minute before reactivating. This algorithm allows
the laser gun to obtain a reading only AFTER you have had 7
seconds to check your speed. The system will provide an alert
when it reactivates itself after the 1 minute shut-down period.
The factory default settings can be changed with a computer
and the included USB Cord.
Using TPX™ Laser Jammer System with the TPX™ Radar
Detector and Laser Detection System
The TPX™ Laser Jammer System can be used in conjunction
with the TPX™ Radar and Laser Detection System. To take
advantage of this functionality, connect the “Laser” output of the
TPX™ Laser Jammer System to the “Laser” input on the TPX™
Radar and Laser Detection System’s Wiring Harness.
When a laser signal is received and jammed, it will trigger the
TPX™ Radar and Laser Detection System. The TPX™ Radar
and Laser Detection System’s Visual Alert will flash, the LCD will
indicate “Laser”, and the Wireless Headset and audio output
will sound alarms if used. This configuration allows the rider
to control all visual and audio signals through the TPX™ Radar
Detector Unit. The TPX™ Laser Jammer System’s Visual Alert is
not required for this situation, but may be used as a secondary
alert method.