Specifications

INSTALLING THE TPX™
WIRELESS HEADSET
Mounting the TPX™ Wireless Headset
The TPX ™ Wireless Headset is designed to be
installed in a full-face or open-face helmet.
Install the Earphone in the helmet’s ear hole or
near the ear, between the foam lining and the
outer shell of the helmet.
Using the included Hook and Loop Fastener, install
the Receiver Module anywhere on the exterior of
the helmet where it will not interfere with the use
of the helmet.
Tuck in loose wires between the foam lining and
outer shell of the helmet.
Installing and Replacing the Battery
The Wireless Headset is powered by a single 3V,
CR-2450 Lithium Coin Cell Battery.
To install the Battery, remove the four screws in
the back of the unit with the included Screwdriver
Keychain. Remove the back cover and install the
Battery into the metal retainer with the positive
side face up. Replace the back cover and secure it
with the four screws.
USING THE TPX™
WIRELESS HEADSET
Power
Press the
button on the TPX™ Wireless
Headset to power the unit on/off. When the unit is
on, the
button will flash once every 3 seconds.
Alerts
When the Main Console receives a radar or laser
signal, it transmits the information to the Wireless
Headset. The Earphone will beep with varying
frequencies and tones to indicate the type and
strength of the detected signal similar to that of
the Main Console.
Unless the Alert Off function is activated, the
Wireless Headset will beep every time a button is
pressed on the Main Console.
To control the volume, refer to Main Console
Operation section of TPX™ Main Console Manual.
Verify that the rubber gasket is seated correctly
and the cover is closed tightly to ensure proper
water resistance.
4 5