Instruction manual

6
Playing a Message
1. When finished recording messages, slide the PLAY/RECORD
switch to the PLAY-1 position. Press down on the Sequencer, and
your message will play back. Press down again, and your next
message will play.
2. To access the second level of messages, slide the PLAY/RECORD
switch to the PLAY-2 position.
3. Optionally access your Sequencer by inserting any external switch
with a standard ⁄” (3.5mm) plug into the jack labeled Ext Switch.
4. To reset the sequence back to the first message, slide the Play/
Record switch to the other level, then back. Play a message, and
it will resume with message one.
Recording a Message
1. Turn on the power by rotating the VOLUME/POWER knob to
mid-position.
2. For level 1, slide the PLAY/RECORD switch to the REC-1 position.
This will record your series of messages into Level-1.
3. Press down on the Sequencer and hold. A beeping cue will occur,
indicating the device is ready to record. When the beeping stops,
speak your message clearly, about twelve inches away, into the
side marked MIC - same side as the speaker. Release the switch
when your message is finished. A continuous beep indicates
that the memory if full for a given level.
4.
To record your next message, press and hold the top of the device
while you speak. Repeat steps 2 & 3 until finished recording all
messages.
5.
If you want to record on Level-2, slide the PLAY/RECORD switch to
the REC-2 position. Record your messages as you did for Level-1.
Remember to wait until the beeping cue has stopped, before
you start speaking.
6. To re-record messages, simply repeat the above steps. Levels
can be recorded in any order! Messages can also be recorded
using an external switch rather than the top of the Sequencer.