Manual

ManualsBrandsAdaptive Technologies ManualsAudio accessoriesMM-008-BT

Figure 1

Figure 2A: Horizontal speaker

adapter plate installation

MultiMount

™

MM-008

Universal Wall and Ceiling Mount Installation Instructions

Thank you for selecting the all weather MultiMount™ MM-008 speaker

mounting kit. This mounting kit contains two speaker mounts that

independently aim and tilt speakers weighing up to 15 lbs/6.8 kg from

most wall and ceiling structures. The MM-008 accommodates speakers

with both single and two hole mounting patterns.

Warning:

Mounting and/or rigging loudspeakers requires experienced

professionals.

Improperly installed loudspeakers can result in

property damage, personal injury or liability to the installing

contractor.

To assure a trouble free installation, read through and follow these

instructions carefully before beginning. If you have doubts about the

integrity of the structure you are mounting to or you are not sure about

the proper hardware to use, consult a structural and/or hardware

specialist.

Be sure that all of the following items are included in this kit before proceeding:

Package Contents:

Item #: Qty Description

1. 2 pcs. Surface mounting plate

2. 2 pcs. Support arm

3. 2 pcs. Speaker adapter plate

4. 2 pcs. U shaped rotator bracket

5. 2 pcs. Snap-on cover plate

6. 2 pc. Hardware kit (for two sets)

Note to installing contractor:

Due to the wide variety of wall and ceiling structures, materials and mounting methods,

these instructions assume that the installer will exercise good judgment in selecting the

proper mounting area and hardware.

As a guide, the installation, when complete should be capable of supporting 5 to 10 times

the actual applied load. We recommend the use of a safety cable (sold separately).

Step 1. Install Mounting Plate:

(a) For wall mounting:

Insert the rubber grommet into the larger

hole of the mounting plate with the radius

edge toward the outside. Install the

mounting plate to the wall with the rubber

grommet facing towards the ceiling using

the appropriate hardware for the

application (Figure 1). If in doubt, consult

a local hardware specialist.

(b) For ceiling mounting:

Predetermine the desired direction of the

speaker then install the mounting plate

with the rubber grommet facing the

direction of the speaker. Use the appropriate hardware for a ceiling mounted application (Figure 1).

Figure 2B: Vertical speaker adapter plate

installation

Summary of content (3 pages)

PAGE 1
MultiMount™ MM-008 Universal Wall and Ceiling Mount Installation Instructions Thank you for selecting the all weather MultiMount™ MM-008 speaker mounting kit. This mounting kit contains two speaker mounts that independently aim and tilt speakers weighing up to 15 lbs/6.8 kg from most wall and ceiling structures. The MM-008 accommodates speakers with both single and two hole mounting patterns. Warning: Mounting and/or rigging loudspeakers requires experienced professionals.
PAGE 2
Step 2: Decide Vertical or Horizontal Speaker Orientation: Horizontal (Figure 2A) or vertical installation (Figure 2B). For speakers with one mounting hole: Use the speaker’s mounting screw to install the adapter’s U-bracket to the speaker (Figure 3A) then attach the support arm to the U-bracket using the included 5/16” button head screws and star washers (Figure 3B).
PAGE 3
Secure support arm to the mounting plate using the 1/4” button head screw, flat washer, rubber gasket and a star washer in between the support arm and the mounting plate (Figure 7B). Do not tighten permanently. Step 6. Setting the tilt angle: While supporting the speaker’s weight, loosen the button head screws at the sides of the speaker adapter plate (do not remove). Position the speaker to the desired tilt angle and hold in position then re-tighten the screws.