Installation Guide

Installation Guide – A22 Amplifier and Wall Speakers

• Both speaker outputs shown above are connected to 2 x 8Ω speakers but can also be connected to a single 8Ω or 4Ω speaker if preferred.

• If the FM tuner is to be used, it is recommended to connect an external FM aerial to the F-connector labelled “FM ANTENNA”

• 2 separate line inputs (CD player, laptop, mp3 player or TV tuner etc.) can be connected to the RCA sockets labelled “AUX 2” and “AUX 3”

• An additional line input “AUX1” is on a 3.5mm stereo jack on the front panel

• A 6.3mm mono jack can accept a microphone input for announcements.

• A pair of RCA connectors on the rear panel labelled “LINE OUT” can be used to link the signal mix of the A22 onto a further amplifier.

PAGE 1
Installation Guide – A22 Amplifier and Wall Speakers • • • • • • Both speaker outputs shown above are connected to 2 x 8Ω speakers but can also be connected to a single 8Ω or 4Ω speaker if preferred. If the FM tuner is to be used, it is recommended to connect an external FM aerial to the F-connector labelled “FM ANTENNA” 2 separate line inputs (CD player, laptop, mp3 player or TV tuner etc.) can be connected to the RCA sockets labelled “AUX 2” and “AUX 3” An additional line input “AUX1” is on a 3.