Instruction manual

Page 4
Revision : 002
BOLERO
Lighting Technologies
Installation
The BOLERO is a professional lighting control desk, developed as per EN60950
safety standard. It is a class 1 equipment designed and manufactured to EN60950.
To prevent any risk of electric shock do not open the desk, there are no user
serviceable parts inside. Refer servicing to trained service personnel exclusively.
Signal Connections
To enhance safety and operating reliability this product has been fitted with galvanic
isolation on the DMX512/1990 output. This isolation has been tested for 500V dc in
order to prevent grounding loop problems or to transfer low voltages occasionally present
on some signals to controls or other signal connectors accessible to the user.
It is absolutely forbidden to apply any voltage to the connections of the BOLERO (Aux,
DMX and Analogue outputs). Connections to inappropriate sources may inadvertently
damage the BOLERO and may be dangerous to the user. It is the user's responsibility
to use the equipment for it's intended purpose and to check the equipement connected
to it.
The BOLERO is a professional equipment developed with simplicity of use in mind.
However, in order to fully benefit from the designed in safety features, the equipment
shall be installed and serviced by skilled and trained personnel exclusively.
Technical Specifications
Power supply : 220V - 240V, 50 Hz ± 1 %.
Mechanical dimensions (mm) (width x depth x height) :
BOLERO 12 BOLERO 24
Packed 530 x 340 x 130 760 x 340 x 130
Unpacked 500 x 315 x 118 730 x 315 x 118
Options and Accessories
• Conversion card for 370uA or 0/+10V analogue output (24 channels).
• Conversion card for 370uA or 0/+10V analogue output (48 channels).
• 5 pin DIN male connector for remote control.
• Dust cover for BOLERO 12.
• Dust cover for BOLERO 24.
GND 1 O
DATA - 2 O
DATA + 3 O
4O
5O
O1 GND
O2 DATA -
O3 DATA +
O4
O5
XLR5-MX
dimmer dependent
Cable : x 2 x 0,34 mm
2
shielded
Max. length : 250 m