Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 11
Issue 1.2
2. GETTING CONNECTED
*
Note: USB option - Standard available on DOMINO 24 U and DOMINO 48U
2.1 POWER INPUT
An IEC mains input socket is located on the rear panel and a POWER switch is beside the
power input. The DOMINO has a universal power supply that will operate on voltages
between 90 volts and 260 volts with a frequency range from 47 to 63 Hz.
2.2 DMX DIGITAL OUTPUT (DMX 512)
The DOMINO 24 and 48 models have a single DMX512 output connector located on the rear
panel. Connect a DMX data cable from the DMX512 output of the DOMINO to the DMX512
input of your equipment (dimmers, moving fixtures etc) and set the required DMX slot
address on your equipment.
2.3 VIDEO MONITOR
If your DOMINO is fitted with the optional VGA output (USB Option), connect a SVGA (or
better) computer monitor to the 15 pin VIDEO connector on the rear of the DOMINO.
See “VIDEO” in the “UTILITIES” section for more details.
2.4 SWITCHING ON
At this point, with the mains power and DMX connected, the DOMINO is ready to be
operated. Simply switch on the “POWER” switch located near the mains input connector on
the rear of the DOMINO.
The DOMINO will commence its start up procedure. After briefly displaying the opening
message, the DOMINO will commence operating in exactly the same state that it was in
when it was last switched off. All the theatrical memories, submaster memories, cue lists,
chasers, patches etc will be as they were.
2.5 SWITCHING OFF
The DOMINO has an inbuilt back up power supply. When the power is switched off (or there
is an unexpected blackout), you will hear a click followed a few seconds later by another
click. The DOMINO keeps operating on its own power supply until the second click is heard.
During this time all memories are automatically saved to non volatile storage.
Product
identity plate
Midi
*
USB
*
Video
*
*
DMX 512
Output
Audio
Input
Desk
lamp
Main input
Fuse Holder
Power
Switch
PS Reset