Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 19
Issue 1.2
5.4.2 A PRESET AND B PRESET
When a Master fader (A preset, B preset) is moved and the sequence
is on, the output level of that Master will always progress towards the
current physical position of that fader at a rate set by the relevant time
setting. If the sequence is off than there is no time. During a time fade
the Go LED will blink.
For example, if a fade time of 3 seconds has been set, then to
execute a fade in exactly 3 seconds, the master must be moved from
bottom to top in less than 3 seconds. If you take longer than 3
seconds to move the master, then the fade will keep pace with the
fader movement. If the master were only faded to the half way
position, then the fade would take 1.5 seconds to reach that point and
then stop. If the master were then moved to the end of its travel, the
fade would take another 1.5 seconds to complete.
5.4.3 Accelerate and slow down
The speed rotating fader allows direct speed control correction at any time while the fade is
running. By turning it to the right, you accelerate; turning it to the left, slow down.
Sequence ON