Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 25
Issue 1.2
7.6.1 CONTINUING AN AUTOMATIC FADE MANUALLY
A fade that is running automatically following its memory times, can be completed manually
to change its look, or to alter its timing.
• Manually move the playback fader pair. There will be no change to the output of the
X-fade until the position of the faders matches the elapsed progress of the fade
(shown on-screen).
• Once the position of the faders has “collected” the progress of the fade, the fade is
under manual control. Any pending wait times are not included in the manual fade:
the lighting state will change as soon as the fade is collected.
7.6.2 MODIFYING THE SPEED OF AN AUTOMATIC FADE
The rate of a crossfade can be modified to speed up or slow down the fade, if the plotted
times are not suitable. The Speed function can be used to modify the fade times before a
crossfade is started, or it can be used ‘live’ to change the fade rate in real time. In both
cases, the playback speed function is assigned to the speed rotation fader.
7.7 STAGE OR PRESET
You may edit theatrical memory live or blind; directly in the theatrical memory list or in the
stage and preset.
To edit in blind press [Edit] press [Preset] or press [Edit] and [ok] and select the theatrical
memory by wheel the [<] or [>] buttons.
To edit in live press; [Edit] press [Stage].
You can change fade and link times and edit the contents of the theatrical memory.
The [function] button flash. Repeated presses of [function] will cycle the display through
channel LEVEL(%), IN time setting, OUT time, link setting and memory number.
The use is described below.
When finished editing, press [edit].
Changes are automatically saved.
7.7.1 CHANNEL LEVELS
To read and/or edit the level of any channel in a theatrical memory, edit the theatrical
memory then press [Function] until level indicator lights.
The display shows the level of the channels in that memory.
To edit the level of the selected channel, press [f/a] of the channel and rotate the EDIT
wheel. If another channel needs to be edited; press [f/a] of the selected channel and rotate
the Edit wheel.
If the level is varied above its recorded value it is prefixed by a + sign. When a parameter is
varied below its recorded value it is prefixed by a - sign. If the level is restored to its original
value no sign is shown.
When finished editing press [edit].
All changes are automatically saved.