Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 39
Issue 1.2
11.8 EDITING A CHASER
“Edit” allows you to permanently change the speed, crossfade, mode and direction plus you
can add or delete steps, connect or disconnect the STL (Sound to Light) processors and edit
the contents of each step.
These changes are applied to the chaser and if the chaser is currently on a submaster, they
will also be applied to the submaster. If the chaser is faded up on stage you will see the
changes. If the chaser is not live on stage, its steps are displayed on the channel LED
indicators and on the optional SVGA monitor.
• To edit a chaser on a submaster, press [edit], [f/a].
• To edit a chaser in the Grab master, press [edit], [f/a]
• To edit a chaser in a different page, press [edit], [Bank B] [f/a]
The indicators in the channel f/a buttons show the channels of the running chaser. Their
intensity reflects the levels of the channels in each step.
• To control the SPEED, rotate the EDIT wheel.
• To change the CROSSFADE between steps, press [function] until both “in” & “out” LEDs
light, then rotate the EDIT wheel.
• To change the MODE or DIRECTION, use the 3 buttons below the EDIT wheel as
described above.
• To connect or disconnect a STL (Sound To Light or SyncoBEAT) from the chaser,
repeatedly HOLD [function] until the STEP number(s) are shown on the display and the
STL button LEDs flash. Whilst holding [function] tap either [STL1] or [STL2].
Press [yes] to connect or disconnect the selected STL. See the “STL and SyncoBEAT”
section for more details.
11.8.1 ADD A STEP
To add a step, first edit the chaser (above), then press [step/stop] to stop the chaser and
continue pressing to step the chaser to the step prior to the point where the new step is to
be added.
Press [add] then either;
• Create the look for the new step on the output and press [record scene]. or
• To add a submaster memory as a step, press; [Bank B] (optional), [f/a] (scene
number). or
If necessary press [>] or [<] to start the chaser again in the desired direction.
When finished editing press [edit].
All changes are automatically saved.
11.8.2 REMOVE A STEP
To remove a step, first edit the chaser (above), then press [step/stop] to stop the chaser and
continue pressing to select the step to be removed.
To remove the step, press [remove], [yes].
If necessary, press [>] or [<] to start the chaser again in the desired direction.
When finished editing press [edit].
All changes are automatically saved.
11.8.3 MODIFY A STEP
To modify the channel levels of a step, first edit the chaser (above), then press [step/stop] to
stop the chaser and continue pressing to select the step to be modified. Press [function]
until the “chan” LED indicator lights and the display reads;
“Pick channel to edit”.