Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 45
Issue 1.2
13.4.4 STARTING A CROSSFADE
To crossfade from the current step to the next step, press;[ >] (forward).
The crossfade will occur with the incoming step fading in, in its IN time and the outgoing step
fading out in its OUT time. The display momentarily shows the step number of the incoming
step.
To momentarily see the step number again, hold down [stop/step] (cue list master).
To continuously see the step number on the display press [select], [cue list flash]. To turn
off the display press [select].
While the crossfade is in progress, the > (forward) button flashes for the duration of the IN
fade and the < (reverse) button flashes for the duration of the OUT fade.
Each press of the [ >] (forward) button will start the crossfade to the next step.
Note: You do not have to wait for a step to complete before starting the next step.
13.4.5 CROSSFADING TO THE PREVIOUS STEP
To crossfade from the current step to the previous step, press;
[<] (reverse).
You may only crossfade back one step. You may however STEP back to any step. See
“STEPPING A CUE LIST” below
13.4.6 STOPPING A CROSSFADE
To stop a crossfade in progress press; [step/stop].
When a crossfade has been stopped, the > (forward) button, < (reverse) button and step/stop
buttons all flash.
13.4.7 STARTING A STOPPED CROSSFADE
To start a stopped crossfade in the forward direction, press;[>] (forward).
To start a stopped crossfade in the reverse direction, press;[<] (reverse).
To momentarily run a stopped crossfade in the current direction;HOLD [step/stop].
The crossfade only progresses whilst [stop/step] is held down.
13.4.8 REVERSING A CROSSFADE
To reverse a crossfade in progress and return to the previous step, press;[<] (reverse).
13.4.9 STEPPING A CUE LIST
If a cue list is stationary (idle between steps), you may step (instant change, no times
executed) through the cue list in either direction.
To instantly step a cue list in the forward direction;HOLD [step/stop], tap [>] (forward).
To instantly step a cue list in the reverse direction;HOLD [step/stop] ,tap [<] (reverse).
13.4.10 RANDOM STEP SELECTION
To randomly jump to any step in a cue list;HOLD [stop/step] and rotate the EDIT Wheel.
The display shows the selected step number. A + or – sign indicates that the selected step is
higher or lower than the current step. The current step has no sign.
When the [stop/step] button is released, the cue list jumps to the selected step.