Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 53
Issue 1.2
16.3 CONNECTED STL INDICATORS
To see all Submasters that are connected to an STL;
HOLD [function], tap [f/a] (stl 1) or (stl 2). HOLD [function].
Submaster connected to the selected STL flash continuously.
To see if an individual submaster is connected to any STL press;
[select], [f/a] (chaser number).
The video screen shows a pinned display of the selected chaser showing any connected
STL’s.
Press [select] to exit.
16.4 STL (SOUND TO LIGHT) MODE
When a chaser is connected to an STL that is in STL mode, the chasers own internal speed
generator continues to step the chaser in addition to the STL stepping from the audio signal.
To give the STL total control, set the chase speed to zero.
Hint; Set the chaser speed to be slower than the beat of the music. If the music stops, the
chaser will continue to run.
Connect a music source to the RCA audio input connector on the rear of the DOMINO. The
best source of audio from your device is the headphone socket as it provides a high level
signal (1-2.5V).
To select STL mode;
HOLD [function], tap [f/a] (stl 1) or (stl 2).
The display scrolls a message showing the current mode of the STL.
Tapping [yes], toggles the STL between either Sound to Light mode or SyncoBEAT mode.
To select STL mode, turn SyncoBEAT OFF.
The current mode of each STL is also shown at the bottom of the main video screen. The
”Volume Control” bargraph indicates STL mode as shown for STL1 in the example below.
The audio level and frequency can now be adjusted to make the chaser step to the beat of
the music.
To adjust the audio level press; [function].
The display shows “L: ##” where ## (0-100) is the audio level.
Rotate the EDIT wheel to adjust the level.
The volume control bargraph on the video also shows the current level. With the music
connected, the Level Bargraph will pulse up and down in time with the music.
Set the level so that the bargraph turns Yellow. Green is too low and Red is too high.
To adjust the audio frequency press; [function].
The display shows “hz ##” where ## (10-600) is the audio frequency.
Rotate the EDIT wheel to select the required frequency.
The Frequency indicator on the video also shows the current setting (low to high frequency).
“Volume Control”
bargraph indicates
STL mode and
shows current
“level setting”.
“B” indicates
SyncoBEAT
mode
Frequency
indicator
Level Bar
g
ra
p
h
“Stepping” Beat indicator