Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 57
Issue 1.2
18. UTILITIES
18.1 STORAGE OPERATIONS
The DOMINO has an optional 2 USB ports. One port is dedicated for USB storage devices;
the other USB port is dedicated for an external trackball (Motion control device). When you
save or load a show from a USB device, you copy the entire contents of the DOMINO. This
includes all Memories, Chasers, Cue lists, SyncoBEATs and the Patch.
18.1.1 SAVE SHOW
To save a show to a USB device place the USB port then;
HOLD [function], tap [f/a] (disk), [yes].
By default, the DOMINO offers a name of “SHOW1”. To accept the show number, press [ok].
To change the show number, rotate the EDIT wheel . Up to 9 show numbers may be used.
To save the show number, press [ok], [yes].
When the save operation is complete press [ok].
Note: Saving a show takes a few moments. During this time normal operation is not possible.
18.1.2 LOAD SHOW
When you load a show from USB device, you replace the entire contents of the DOMINO
with the show data from the disk.
WARNING: Once a load from USB device is initiated, the current contents of the DOMINO
will be erased and cannot be recovered.
To load a show from USB device;
HOLD [function], tap [f/a] (disk), [no], [yes].
Rotate the EDIT wheel to select the show number. To load the show, press [ok], [yes].
When the load is complete press [ok].
Note: Normal operation is not possible whilst a show is loading.
18.2 RESET
The DOMINO provides two types of reset function. SYSTEM reset and TOTAL reset.
18.2.1 SYSTEM RESET
In the unlikely event that the DOMINO fails to respond, the operating system may be reset so
that the software may recommence normal operation. See also “POWER ON RESET” below.
Performing a system reset selects “A/B” mode but will not affect any of the recorded
submaster memory.
To perform a SYSTEM RESET;
HOLD [function], tap [f/a] (reset), [yes], [yes].
18.2.2 TOTAL RESET
Total Reset will ERASE all the recorded memory from the DOMINO and reset the operating
system. See also “POWER ON RESET” below.
To perform a TOTAL RESET
HOLD [function], tap [f/a] (reset), [no], [yes], [yes].