Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 58
Issue 1.2
18.2.3 POWER ON RESETS
If the DOMINO is not responding you will not be able to perform a reset as described above.
In this case, switch off the DOMINO and wait for approximately 10 seconds then;
• To perform a “system reset” at switch on; HOLD [function], switch on, release
[function].
• To perform a “TOTAL reset” at switch on (also known as a COLD START);
HOLD [no] + [yes], switch on the power and when the scrolling message finishes,
release [no] + [yes].
18.3 MEMORY PROTECT
The DOMINO can be locked to prevent unauthorised changes. Three levels of lock are
available.
Hint: Always save your show before locking the DOMINO.
HOLD [function], tap [f/a] (set-up).
The display asks “Lock Console?”
• Lock PATCH. The patch cannot be edited
• Lock SAVE. Memories cannot be saved or edited.
• Lock All. The current DOMINO output continues but all controls are locked except for the
[function] button which is used to unlock the DOMINO.
You can select any of the three options by pressing its [PM] button. The selected option
flashes. To accept the flashing option press;[yes].
The display scrolls “Enter Code”. Two levels of security are available:
• For low level security without a code press [ok], [ok].
• For high level security use the channel B [f/a] buttons 1 to 9 (use 10 as 0) to enter a 1 to
4 digit lock code then press [ok].
Repeat the same digits then press [ok].
The console is now locked.
18.3.1 UNLOCK
To unlock the DOMINO;
HOLD [function], TAP [f/a] (set-up).
The display asks “Unlock Console?”.
Press [yes].
The display scrolls “Enter Code”.
• If the console was locked with low level security simply press [ok].
• If the console was locked with high level security use channel B [f/a] buttons 1 to 9 (use
10 as 0) to enter the same digits used to lock the console then press [ok].
The console is now unlocked.
18.3.2 LOST LOCK CODE
If you lock the DOMINO and forget the code you have two choices:
1. email [e-mail]
or contact your local ADB agent including the serial
number of your DOMINO (located on the rear panel). An unlock code will be emailed to you
(or your agent).
2. Perform a “Cold Start” which does a total reset and destroys ALL memories and show
information. To perform a cold start, switch OFF the DOMINO and wait for 30 seconds.
HOLD down the [yes] + [no] buttons and switch ON the DOMINO. Wait until the scrolling
message finishes then release the two buttons.