Operation Manual

DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 37
Issue 1.2
11.6 CHASER INTENSITY
The OVERALL level of a chaser is controlled by the submaster containing the chaser.
The chaser can be faded in or out as required (its fade times are controlled manually) or the
chaser may be “Flashed” (soloed or bumped) via its [f/a] button.
If the chaser is faded down to zero, the chaser automatically stops.
11.7 CONTROLLING A CHASER
“Select” allows you to change the speed, crossfade, mode and direction of the copy of the
chaser in the selected submaster without affecting the original chaser. To make permanent
changes to a chaser see “Editing a Chaser” below.
Press [select], [f/a] (chaser to control), [function].
• To control the SPEED, rotate the EDIT wheel. The display shows the speed in Beat per
Minute.
• To change the CROSSFADE between steps, press [function] until both “in” & “out” LEDs
light, then rotate the EDIT wheel. The display indicates the percentage of time between
steps to be used for the crossfade. See CROSSFADE for more details
• To change the MODE or DIRECTION use the 3 buttons below the EDIT wheel as follows;
BUTTON ACTION
[step/stop] STOPS a running chaser or STEPS
a stopped chaser
[>] (Forward)
RUNS A CHASER FORWARD
[<] (Reverse)
RUNS A CHASER REVERSE
Hold [>] Tap [<] Selects BOUNCE mode
[>] or [<]
De-selects BOUNCE mode
Hold [step/stop] Tap [>] Selects SINGLE SHOT mode
[>] or [<] RUNS A SINGLE SHOT
Hold [step/stop] Tap [>]
De-selects single shot mode
When finished controlling press [select].
The changes that you have made are retained in the submaster until such time as the chaser
is replaced on that submaster (by changing pages or mode).
To restore the original content to the submaster press [copy], [f/a] to the same [f/a].
11.7.1 STEPPING A CHASER
A chaser may be manually stepped at any time by pressing its [f/a] button. If the chaser is
already running, this will immediately step it to the next step.
To manually step a chaser, stop the chaser (above), then step it by pressing its [f/a] button.
11.7.2 RUNNING A SINGLE SHOT
If a chaser has been set to “single shot” mode (above), pressing its [f/a] button will run a
single shot.