Service manual

Technical Description
www.adblighting.com Service Manual - page 21
Issue 0.9
6.2 Explanation of the interconnection diagram
WARP/M has 14 “3 phase steppers”. Those steppers are controlled by 3 drive-boards (PCB 1525).
The position of the steppers for pan/tilt is detected by Magneto-resistance sensors; for the other
functions by Opto sensor. All control and feedback information is centralized in the Main processor
board; top box (PCB 1525).
The communication, between the different parts is called WARP link protocol.
Below each part in detail: