Service manual

Technical Description

www.adblighting.com Service Manual - page 27

Issue 0.9

6.3.1.4 Functions:

This board PCB 1496 is designed to:

• Receive / Send DMX 512

• Translate DMX in WARP Protocol

• Ethernet communication

• Control and Supply of the Motor Boards

• Technician Interface (Display Menu)

• Control of built-in dimmer and ballast (for WARP/M/DIM and WARP/H/HMI)

• Update of software in other boards

6.3.1.5 Components:

Components you can change on this board are:

• Fuse 3A (spare part code 1001.65.300)

• Display (see front photo: 2 last slots are free)

6.3.1.6 Power-up procedure:

When you switch on the WARP/M

1. Only LED Power on

2. Wait approximately 30 s until all LED is on and Display write WARP or DMX- before motors

resetting