Service manual

Motorised Yoke
Service Manual - page 50 www.adblighting.com
Issue 0.9
7.13 Replace Coarse PAN AMR Sensor
Required Tool(s) Spare Part Code
Preliminary reading
Screwdriver PZ2 1001.65.230
Chapter 7.1
Chapter 6.1
1. Switch OFF and Unplug the WARP
2. Disconnect sensor wire
3. Remove the 2 Taptite screws
4. Replace the Sensor Magnetic using new screws
Important:
• The first time you replace AMR SENSOR, you
have to replace all taptite screws By TCBC M4x8
ZN DIN 7985-Z.
• When you re-start the WARP you have to re-
calibrate PAN AXIS.
• This can be started from web page, desk or local
display.
1001.65.230
1001.65.230 includes:
 1 Sensor cable
 3 Screws M3*10
 3 Washers + 3 nuts
 2 cable ties
Note:
Distance between sensor
and magnet should be
a
r
ou
n
d
1 mm.