Service manual

Motorised Yoke
www.adblighting.com Service Manual - page 51
Issue 0.9
7.14 Replace fine TILT AMR Sensor
Required Tool(s) Spare Part Code Preliminary reading
Screwdriver PZ2 1001.65.230
Chapter 7.1
Chapter 6.1
1. Switch OFF and Unplug the WARP
2. Disconnect sensor wire from Fine Tilt Sensor
3. Remove the 2 taptite screws
4. Replace the Sensor Magnetic using new screws
Important:
• The first time you replace Fine Tilt AMR
SENSOR, you have to replace all taptite
screws by TCBC M4x8 ZN DIN 7985-Z.
• When you re-start the WARP you have to re-
calibrate Tilt Axis.
• This can be started from web page, desk or
local display.
1001.65.230
Note:
Distance between sensor
and magnet should be
around 1 mm.
1001.65.230 includes:
 1 Sensor cable
 3 Screws M3*10
 3 Washers + 3 nuts
 2 cable ties