Service manual

Motorised Yoke
www.adblighting.com Service Manual - page 53
Issue 0.9
7.16 Replace TILT Belt
Required Tool(s) Spare Part Code
Preliminary reading
Screwdriver PZ2
H 5
1001.65.680
Chapter 7.1
Chapter 7.7
Chapter 7.14
1. Switch OFF and Unplug the WARP
2. Remove Right Board (see chapter 7.7) and the Fine AMR Sensor (see chapter 7.14)
3. Loose 4 screws on the Tilt Motor Suspension Plate
4. Slide up the Motor to get free the Belt
5. Remove the belt turning the Tilt axis
Important:
• If you remove the Fine Tilt Sensor, you
have to replace all taptite screws By
TCBC M4x8 ZN DIN 7985-Z.
• When you re-start the WARP after
moving AMR Sensor, you have to re-
calibrate PAN AXIS.
• This can be started from web page or
desk or local display.
1: Loosen the 4 Screws
4
1001.65.680
3
2
1001.65.680 includes:
 1 Belt
 2 Screws M3*108
 2 Washers + 2 nuts