Service manual

Motorised Yoke
www.adblighting.com Service Manual - page 67
Issue 0.9
7.26 IR Sensor
Required Tool(s) Spare Part Code Preliminary reading
Screwdriver PZ1
1001.65.270 Right
1001.65.260 Left
Chapter 7.22
1. Remove the Motor Wing from the WARP (see chapter 7.22)
2. Remove the 3 Screws from the motor Wing
3. Remove the Plate protection and the IR board.
4. Replace the board using new screws and nylon washers (one beneath and one above the
board on each M3 Insert, put blue Loctite 243 on screws)
Important:
¾ Don’t forget Nylon Washer on each side
of the board (can’t work without)
¾ Take care of insulation above the board
Notice:
¾ In factory, M3 screws are stop with
Loctite Glue 243; if difficult to remove,
use a hot air gun to un-stick.
1001.65.270 includes:
• 1 IR Board Right with
Insulation
• 4 Screws M3*6 PZ1
• 8 Nylon Washer
1001.65.260 includes:
• 1 IR Board Left with Insulation
• 4 Screws M3*6 PZ1
• 8 Nylon Washer
Insulation sticker
N
y
lon Washers
CAUTION:
¾ It is very important to respect
motors and IR board setting (see
chapter 7.26.2)
¾ You must have a photoelectric
cell in front of each
g
ear