Service manual

Motorised Yoke
www.adblighting.com Service Manual - page 75
Issue 0.9
8.2 Remove / Change the light Box
Required Tool(s) Spare Part Code Preliminary reading
Hexagonal H4 1001.61.020
Chapter 7.17
Chapter 7.22.1
1. Unplug the WARP and remove the lamp:
2. Remove the WARP from the motorised Yoke (see chapter 7.17)
3. Remove the 2 screws into the rings compartment using H4
4. Remove / Replace the Light Box and the 4 Plastic spacers
WARNING:
Don’t forget the 4 plastic spacers
when you replace the light Box
2
Plastic Spacer
1001.61.020 includes:
 1 complete light box
 2 Screws M5 * 40 + 2nuts
 4 plastic Spacers
 10 cable tie
 1 x 3-pole connector
1
2
1