Service manual

Motorised Yoke

Service Manual - page 76 www.adblighting.com

Issue 0.9

8.3 Replace the Reflector

Required Tool(s) Spare Part Code Preliminary reading

Hexagonal H4

Pozidrive PZ2

1001.61.010 Chapter 8.2

1. Unplug the WARP and remove the lamp:

2. Remove the Light Box from the WARP (see Chapter 8.2)

3. Remove the 2 Cones for heat

4. Remove screws M3 on the Front of the cone (PZ2)

5. Remove Screws H4 on the back (near the Peak and Flat)

6. Open the Light box

7. Replace the Reflector

Cone for Heat

Reflector Spring

WARNING:

First Time you change the reflector, you

have to replace taptite screws (front of the

sink) by screws M3*12 (provided with

spare parts 1001.60.010)

1001.61.010 includes:

 1 reflector

 4 reflector Springs

 2 Screws M 3 * 12 + 2 washers

 2 Nuts M3 auto block

 1 connector 3pts and 3 crimps