Service manual

WARP Head
www.adblighting.com Service Manual - page 89
Issue 0.9
8.10 Replace Teflon Ring
Required Tool(s) Spare Part Code Preliminary reading
Flat Screw Driver
Screw Driver PZ2
1001.61.360 Chapter 8.11
Important:
After a few years of operation, it could be necessary to change the Teflon ring to
facilitate the sliding of the lenses.
1. Unplug the WARP
2. Open Covers and remove Filter Cassette (see chapter 5.12)
3. Remove Diaphragm (see chapter 5.14)
4. Unlink the 2 lenses from belts (remove screws and nuts from the belt clip)
5. Slide and remove completely lenses support from arms
6. Change all Teflon parts as initially assembled on each lens support
7. Replace lenses into arm profile
8. Replace Diaphragm Filter Cassette and covers
1001.61.360 includes:
 10 Lens Stears
 5 Lens Opened Stears
 3 Lens Gliders
1001.61.360
Glider
WARNING:
DON’T Remove clip from belts if not
you have to put correctly as written on
chapter 8.4.2)