User's Manual Part 2

4-13
Remote Antenna Unit (RAU) Installation
5 Connect UTP/STP cables from RAUs
Connect all UTP/STP cables coming from
the RAUs to any available RJ-45
connector on the Expansion Hub.
The Expansion Hub fiber port
LINK STATUS
and
SYNC
LEDs should be
green or off.
The
LINK STATUS
and
SYNC
LEDs on each
Expansion Hub port should remain red
until the RAU is connected on the other
end.
1 Connect Antennas
Connect an accessory antenna to each
RAU SMA connector. (The illustration
shows the RAU with an optional Rubber
Duck antenna.)
When connecting to the SMA
connector on the antenna,
DO
NOT
over-tighten the
connector. Firmly hand-
tightening the connector is adequate.
TENNA PORTS
LGCell
™
E
DOWN
MAIN HUB PORTS
UP
SYNC
POWER
AC POWER
ANTENNA POR
TS
LGC
WIRELESS
LGCell
™
Expansion Hub
LINK
STATUS
SYNC