User's Manual Part 4

4-5
•
Live work:
Live work is permitted on the LG
Cell
as it is a Class 1 hazard.
•
Signs:
No warning signs are required.
•
Test equipment:
Use Class 1 test equipment.
Cable and Connector Requirements
The LGC
ell
equipment operates over standard TIA/EIA 568-A specification,
Category 5 (CAT 5), or better, Unshielded Twisted Pair (UTP) or Shielded Twisted
Pair (STP) and standard 62.5
µ
m/125
µ
m Multi-Mode Fiber cable (MMF), at a
wavelength of 1300 nanometers (nm).
These cables are widely used industry standards for Local Area Networks (LANs).
The regulations, guidelines, and standards for cable installation are identical to
those specified by the TIA/EIA 568-A standard for LANs. See
Appendix B – TIA/
EIA 568-A Cabling Standard.
LGC Wireless recommends Plenum rated CAT 5 UTP/STP and MMF cable and
connectors for conformity to building codes and standards.
LGC
ell
Standard Equipment
• LGC
ell
Main Hub
• LGC
ell
Expansion Hub
• Remote Antenna Units (RAUs) with an in-building antenna
• Four screws for mounting the RAUs
• Four rack mount screws per hub to mount hubs into a 19" rack
•
Installation and Reference Guide
LGC
ell
Equipment Installation
The following are procedures for installing an LG
Cell
system. Pre-testing the
system is not required. The installation procedures are based on the following
assumptions:
• The LGC
ell
equipment has been unpacked and inspected.
• Locations for the Main Hub, Expansion Hubs, and RAUs have been identified.
• 19" rack space is available in the wiring closets.
• AC power is available for the LG
Cell
.
• MMF and UTP/STP have been pulled into place (based on previous design)
and terminated.