User's Manual Part 6

E-16 Appendix E – Alarm Report Monitor (ARM2000)
Alarm and Device Setup
During the initial test after you complete the setup, PCARM displays the
appropriate clear and alarm conditions. To acknowledge these conditions, click the
ACK button on the Device View screen. During initial setup, all 16 devices are
assumed to be enabled.
Disabling Alarms and Devices
To disable an alarm, place the mouse pointer over the alarm and right click.
PCARM displays a dialog box that asks if you want to be reminded to enable after
an elapsed time. Make your selection of time and press Enter. The alarm is disabled
at this point, both in PCARM and on the REMOTE UNIT display panel.
You can also enable a device in this manner from the System View screen.
Enabling Alarms and Devices
To enable an alarm, place the mouse pointer over the desired alarm and right click.
PCARM displays a dialog box that gives you options to enable or cancel. Click the
enable options, or press
E
on the keyboard to enable them. (If you attempt to enable
an alarm when appropriate conditions have not been met, the alarm indicator (red
LED) flashes and the PC buzzer sounds.)
You can also enable a device in this manner from the System View screen.