User's Manual Part 6

E-22 Appendix E – Alarm Report Monitor (ARM2000)
Window Status Indicators
Device Selection
To view a particular device, position the cursor over the window of the device and
click the right button. This transfers the program into the device view mode. See
“Device View Screen” on page 25.
Disabling Devices
You can disable devices to allow maintenance of the monitored equipment
without receiving false alarms. To disable a device, position the cursor over the
device and click the right mouse button. PCARM displays a dialog box that
prompts you to enter a reminder time. Enter a desired amount for timer (in
minutes) to be reminded that the device has been disabled, or 0 for no reminder.
Enabling Devices
To enable a device, position the mouse over the desired disabled device and
click the right mouse button. This will cause a confirmation dialog box to be
displayed. To enable the device, click the Enable button on the dialog box or
press the ‘E’ on the keyboard. To cancel, click the Cancel button, press the
‘ESC’ or ‘C’ key on the keyboard.
Window State Condition
Green All circuits clear and acknowledged.
Red Alarm condition on one or more channels. All alarms are acknowl-
edged.
Green Flashing Unacknowledged clear event on one or more channels.
Red Flashing Unacknowledged alarm on one or more channels.
Red/Green Flashing Both alarms and clears that are unacknowledged.
Blue Flashing Unit is not responding to polls.
Yellow The device is output only.
Gray Unit is not programmed.
Black Device has been disabled.