User's Manual

PN 8100-40 Help Hot Line (U.S. only): 1-800-530-9960 8-5
620004-0 Rev. B
Safety Precautions
8.2.2 General Safety Precautions
The following precautions apply to LGCell products.
• LGCell has no user-serviceable parts. Faulty or failed units are fully replaceable
through LGC Wireless. Please contact us at:
1-800-530-9960 (U.S. only)
[phone] (International)
[phone] (Europe)
• Never input an RF signal to the Main Hub’s duplex or simplex ports that is higher
than those defined in Section 7.1 on page 7-3 because the Main Hub could be dam-
aged.
• Although modeled after an Ethernet/LAN architecture and connectivity, LGCell
units are not intended to connect to Ethernet data hubs, routers, cards, or other sim-
ilar data equipment.
• When you connect the multimode fiber (MMF) optical cable, take the same pre-
caution as if installing Ethernet network equipment. All optical fiber ST connec-
tors should be cleaned according to the connector manufacturer’s instructions.
• When you connect a radiating antenna to an RAU, DO NOT over-tighten the SMA
connector. Firmly hand-tightening the connector is adequate.
WARNING: To reduce the risk of fire or electric shock, do not
expose this equipment to rain or moisture.