User Manual

ADCP-75-192 • Issue 1 • December 2005 • Section 3: Network and System Installation and Setup
Page 3-27
 2005, ADC Telecommunications, Inc.
11.2.4 Site ID
transceptRanNodeTable.transceptRanNodeSiteID
This entry displays the RF Network’s Site ID where each RAN is installed. In conjunction with
the Pole Number, this is the mechanism used to pinpoint any RAN’s physical location. GPS
can also be used, where available. The Site ID may be 64 characters long.
Note: For tenant information propagation to occur, this field must be populated.
11.2.5 RucXPaY Connection
transceptRanNodeTable.transceptRanNodeRucXPaYConnection, where X=1-3, Y=1-2
These entries manually record the RF connection path between the RAN UpConverter’s RFA
outputs and the antenna. For example, if the RFA attached to RUC A1’s “1/3” output is connected
to a PCS ADB RFA, then transceptRanNodeTable.transceptRanNodeRuc1Pa1Connection should
be set to “pcsADB”. This data is best gathered at installation time. Repeat for all RUCs and RFAs
as necessary.
The RFA configuration options are pcsA, pcsB, pcsC, pcsD, pcsE, pcsF, smrA, smrB,
pcsADB, pcsEFCG, smrA, smrB, cellA, and cellB.
11.2.6 RdcZ Multicoupler/LNA Connection
transceptRanNodeTable.transceptRanNodeRdcZMucOrLnaConnection, Z=1-5
These entries manually record the RF connection path between the RAN downConverter’s
outputs and the RFA. For example, if the RFA attached to RDC A2’s output is connected to a
PCS ADB RFA, then transceptRanNodeTable.transceptRanNodeRdcZMuOrLnaConnection
should be set to “pcsADB”. This data is best gathered at installation time. Repeat for all RUCs
and RFAs as necessary.
The Multicoupler/LNA configuration options are pcs, cell, smrA, smrB, cellSMR
11.2.7 Invalid
transceptRanNodeExtTable.transceptRanNodeExtInvalid
This entry resides in the "expansion" table of the RAN Node MIB. If a node in the network
that is now found to be a Hub node resides in the RAN Node MIB (i.e. was previously resident
in a RAN), the Invalid field in the RAN Node MIB will be set to true. This will alert the NMS
to clear that node entry in the RAN Node MIB.
11.2.8 Clean
transceptRanNodeExtTable.transceptRanNodeExtClean
This entry resides in the expansion MIB table of the RAN Node MIB. The RAN Node MIB
keeps a history of every RAN ever seen by the Hubmaster node. At times these entries will
become invalid as CPUs are swapped out, etc. To remove old and unwanted node information