User Manual

ADCP-75-192 • Issue 1 • December 2005 • Preface
Page iv
 2005, ADC Telecommunications, Inc.
TABLE OF CONTENTS
Content Page
6.1 Full Band Hub Down Converter (FBHDC) ............................................. 2-17
6.2 Forward Simulcast Card (FSC) .................................................... 2-18
6.3 Hub Upconverter Card (HUC) ..................................................... 2-19
6.4 Reverse Simulcast Card (RSC) .................................................... 2-20
6.5 Hub Reference Module (HRM) ................................................... 2-22
6.6 Ethernet Hub ................................................................ 2-24
6.7 BTS Interface Module (BIM) ..................................................... 2-25
6.8 Attenuator Shelf .............................................................. 2-28
7 RADIO ACCESS NODE (RAN) SPECIFIC MODULES ............................................. 2-29
7.1 Ran Down Converter (RDC or RDC2) ............................................... 2-29
7.2 Ran Up Converter (RUC2.X or RUC3) ............................................... 2-30
7.3 AC Power Entry Controller (APEC) .................................................. 2-31
7.4 DC Power Entry Controller (DPEC) ................................................. 2-32
7.5 CompactPCI Power Supply (cPCI P/S) ............................................... 2-34
7.6 RF Assembly Module (RFA) ..................................................... 2-35
7.7 Specifications ............................................................... 2-41
SECTION 3
NETWORK AND SYSTEM INSTALLATION AND SETUP
1 INTRODUCTION ..................................................................... 3-2
2 NETWORKING OVERVIEW .............................................................. 3-2
3 NODE IDENTIFICATION SCHEMES ......................................................... 3-3
4 IDENTIFICATION USING THE NETWORK IP RECEIVER/SENDER SYSTEM................................ 3-3
5 HUB EQUIPMENT IDENTIFICATIONS ....................................................... 3-3
6 ASSIGNING TENANTS ................................................................. 3-5
6.1 Understanding Tenant MIB Indexing.................................................. 3-5
6.2 BTS Connection MIB ............................................................ 3-6
6.3 Pathtrace Format .............................................................. 3-9
7 TENANT CONFIGURATION ............................................................. 3-13
7.1 Setting Protocol .............................................................. 3-13
7.2 Setting Channels ............................................................. 3-13
7.3 Setting Hub Measured Forward Gain ................................................ 3-13
7.4 Setting RAN Measured Forward Gain ................................................ 3-13
7.5 Setting FSC Gain ............................................................. 3-13
7.6 Setting RAN Forward Gain Offset ................................................... 3-14
7.7 Setting Reverse Gain........................................................... 3-14
7.8 Setting Reverse Cable Loss ...................................................... 3-14
7.9 Using Tenant Reset............................................................ 3-14
7.10 Enabling FGC / RGC............................................................ 3-14
7.11 Using Tenant Mode ............................................................ 3-15
7.12 Enabling / Disabling Delay Compensation ............................................. 3-15
7.13 Setting Forward / Reverse Delay Skew ............................................... 3-15