User Manual
Table Of Contents
- SECTION 1: Overview
- SECTION 2: Description
- SECTION 3: Host Unit Installation
- SECTION 4: Operation
- SECTION 5: Maintenance
- SECTION 6: General Information
- ABOUT THIS MANUAL
- RELATED PUBLICATIONS
- ADMONISHMENTS
- GENERAL SAFETY PRECAUTIONS
- STANDARDS CERTIFICATION
- LIST OF ACRONYMS AND ABBREVIATIONS
- SECTION 1: Overview
- SECTION 2: Description
- SECTION 3: Host Unit Installation
- 1 before starting installation
- 2 OSP Fiber Cable Installation Guidelines
- 3 WDM mounting procedure (optional accessory)
- 4 HU mounting procedure
- 5 Chassis ground connection
- 6 coaxial cable connections
- 7 optical connections
- 8 controller area network connections
- 9 service interface connection
- 10 external alarm system connections
- 11 dc power connections
- SECTION 4: Operation
- 1 before starting operation
- 2 turn-up system and verify operation
- 2.1 Turn-Up Procedure
- 2.2 Download HU and RU System Software
- 2.3 Determine Forward Path Input Signal Level
- 2.4 Enter Site Name and Site Number
- 2.5 Enter Host Forward Attenuation
- 2.6 Determine Output Signal Level at STM Antenna Port
- 2.7 Enter Remote Forward Attenuation
- 2.8 Enter Host Reverse Attenuation
- 2.9 Enter Host Forward and Reverse Delay
- SECTION 5: Maintenance
- SECTION 6: General Information
ADCP-75-126 • Issue B • April 2002 • Section 4: Operation
Page 4-10
©
2002,
ADC
Telecommunications,
Inc.
2.4 Enter Site Name and Site Number
All
HU’s
and
RU’s
are
programmed
with
the
same
site
name
and
site
number.
It
is
therefore
necessary
to
assign
a
unique
site
name
and
site
number
to
the
HU
and
RU
before
they
can
be
connected
to
the
same
CAN.
Use
the
following
procedure
to
assign
a
unique
site
name
and
number
to
each
HU
and
RU
system:
1. Click
on
the
HOST
Config
tab
and
on
the
REMOTE
Config
tab.
The
HOST
Config
display
and
the
REMOTE
Config
display
will
open
within
the
EMS
main
window
as
shown
in
Figure 4-6.
Figure 4-6. HOST and REMOTE Config Displays
2. Right-click
on
the
HOST
Site
Name
field
(see
Figure 4-6).
The
Site
Name
pop-up
screen
will
open
as
shown
in
Figure 4-7.
Enter
a
unique
name
for
the
HOST.
The
name
may
be
up
to
32
characters
long
and
must
not
contain
any
spaces.
The
name
may
include
numbers,
punctuation,
and
upper
or
lower
case
letters
and
must
always
begin
with
a
letter.
Click
on
OK
to
close
the
screen
and
make
the
changes
take
effect.
Figure 4-7. HOST Site Name Pop-Up Screen
HOST Site Number
HOST Site Name
REMOTE Site Number
(Entered automatically
when the HOST site
number is selected)
REMOTE Site Name
Right-Click on the
point shown to open
pop-up screen