User Manual
Table Of Contents
- ABOUT THIS MANUAL
- RELATED PUBLICATIONS
- ADMONISHMENTS
- GENERAL SAFETY PRECAUTIONS
- STANDARDS CERTIFICATION
- LIST OF ACRONYMS AND ABBREVIATIONS
- 1 DESCRIPTION
- 2 HARDWARE AND SOFTWARE REQUIREMENTS
- 3 APPLICATION
- 4 EMS SOFTWARE GRAPHICAL USER INTERFACE
- 5 TROUBLESHOOTING AN RLM ALARM
- 6 CUSTOMER INFORMATION AND ASSISTANCE
ADCP-75-191 • Preliminary Issue B • November 2005
Page 3
© 2005, ADC Telecommunications, Inc.
4 EMS SOFTWARE GRAPHICAL USER INTERFACE
The RLM alarm message is recognized by the Version 7.0 EMS software and displayed as a
Major alarm on the HOST Alarm screen as shown in Figure 2. When an RLM alarm message is
received, the Reverse Link Fault indicator will change from green (normal) to red (alarm).
Figure 2. Host Unit and Remote Unit Alarm Screen
The EMS software also indicates whether or not the Host Unit and Remote Unit hardware
support the RLM feature. If the Host Unit supports RLM, the Host Unit HOST screen will
display the message “RLM supported” as shown in Figure 3. Similarly, if the Remote Unit
supports RLM, the STM screen will display the message “RLM supported”.
Figure 3. Host and STM Screens
Indicator for Reverse
Link Monitor
RLM supported by
Host Unit
RLM supported
by Remote Unit