User's Manual

Document Title: WiMAX Gen 1 Spécification

REV

Page

Rev 3

1 of 4

Filename: WiMAX Gen1

System Specification

Rev3.doc

When printed or copied, document is for REFERENCE ONLY as of,

03/07/08

LGC Wireless Confidential

1 Purpose

Purpose of this document is to list WiMAX Gen1 System Specifications.

2 Scope

This specification establishes the performance requirements for the WiMAX distributed antenna

system (DAS).

3 Responsibility

LGC Wireless is responsible for maintaining this document.

4 System Level Specification

4.1 Operating Frequencies

WiMAX Gen1 will have two frequency bands. This will allow customer to run Band 1 as main band and

Band 2 as MIMO. Second, it allows customer to run two independent bands for example one could be

sector 1 and other could be sector 2 with same or different frequency.

4.1.1 WiMAX Frequency Band 1:

WiMAX Band 1 has four sub bands that cover Complete WiMAX band from 2496-2690MHz in 60MHz sub

bands.

These tables might change based on marketing requirements.

Downlink Uplink

Band

RF Passband (MHz) RF Passband (MHz)

WiMAX B1 2496 - 2556 2496 - 2556

WiMAX B2 2546 - 2606 2546 - 2606

WiMAX B3 2596 - 2656 2596 - 2656

WiMAX B4 2630 - 2690 2630 - 2690

4.1.2 WiMAX Frequency Band 2:

WiMAX Band 2 has four sub bands that cover Complete WiMAX band from 2496-2690MHz in 60MHz

sub bands.

Downlink Uplink

Band

RF Passband (MHz) RF Passband (MHz)

WiMAX B1 2496 - 2556 2496 - 2556

WiMAX B2 2546 - 2606 2546 - 2606

PAGE 1
Document Title: WiMAX Gen 1 Spécification REV Rev 3 1 Page 1 of 4 Purpose Purpose of this document is to list WiMAX Gen1 System Specifications. 2 Scope This specification establishes the performance requirements for the WiMAX distributed antenna system (DAS). 3 Responsibility LGC Wireless is responsible for maintaining this document. 4 4.1 System Level Specification Operating Frequencies WiMAX Gen1 will have two frequency bands.
PAGE 2
Document Title: WiMAX Gen 1 Spécification REV Rev 3 4.
PAGE 3
Document Title: WiMAX Gen 1 Spécification REV Rev 3 Operating Humidity; non-condensing 6 Page 3 of 4 5% to 95% 5% to 95% Cabling Specifications: Parameter Specifications Optical Fiber These specifications assume that the fiber optic cable, single-mode, is Corning with SC/APC connectors.
PAGE 4
Document Title: WiMAX Gen 1 Spécification REV Rev 3 Page 4 of 4 Note Section 8 and 9 are for internal use only. They are for ATE configuration. 8 Main Hub TDD Requirements: TDD Duplex port or Simplex ports will be configured in manufacturing based on customer requirements. 8.1 MH TDD threshold configuration: Main Hub threshold is configured at ATE. Each band and each Sub Band have different threshold and memory location. MH will switch to Downlink at input power of -10dBm.