Operating instructions

Using the ADC1000-USB: Serial Mode
Serial Port Overview
Interface the ADC1000-USB to the Spectrometer
If you ordered your S2000 or S1024DW Spectrometer and ADC1000-USB A/D Converter at the
same time, the spectrometer and the A/D converter should share one housing (see the
ADC1000-USB-S Notes section in this chapter). However, if you already owned a spectrometer
and then purchased the ADC1000-USB separately, you must interface the ADC1000-USB to the
back of the spectrometer. The picture below illustrates this connection:
S2000 or S1024DW Spectrometer ADC1000-USB AC Power Supply
(included with ADC-USB-SER kit)
Connect the ADC1000-USB to your Serial Port
To use the serial port on the ADC1000-USB, the PC to which it is interfacing must have a 32-bit
Windows operating system.
Follow the steps below to connect the ADC1000-USB to the computer via the serial port:
1. Connect one end of the serial cable to the ADC1000-USB and the other end of the serial
cable to a serial port on your PC.
2. Note the serial port number (also called COM Port) on the PC to which you are
interfacing. Some PCs may not have numbered ports.
ADC1000-USB Operating Instructions 9
3. Plug the power supply into an electrical outlet and connect it to the ADC1000-USB.