Instruction manual

ManualsBrandsADC ManualsBlood Pressure Monitor6015

c) Secure the cuff with the hook and loop adhesive so that it lies comfort-

ably and not too tight. It should be comfortable.

d) Lay your arm on a table with your palm upwards. Support your arm with

a cushion so that the cuff rests at about the same height as the heart. Remain still

for 2 minutes, sitting quietly, before beginning a measurement.

6.4. Measuring procedure (Measure in a seated position only. Stay

still.)

After the cuff has been appropriately positioned, and your arm is supported at

heart level, the measurement can begin:

a) Press the Start/Stop button. The pump begins to inflate the cuff. In the

display, the increasing cuff pressure is continually displayed.

b) After automatically reaching the correct inflation pressure, the pump stops

and the pressure slowly falls.The cuff pressure (large characters) is dis-

played during the measurement. When the device has detected the pulse,

the heart symbol in the display begins to blink and a beep tone is audible

for every pulse beat.

c) When the measurement is complete, a long beep tone sounds. The meas-

ured systolic and diastolic blood pressure values as well as the pulse are dis-

played.

The measurement results are displayed until you switch the device off by pressing

the START/STOP button. If no button is pressed for 5 minutes, the device switches

off automatically to save the batteries.

6.5. Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for any reason (e.g. the

patient feels unwell), the Start/Stop button should be pressed at any time. The de-

vice then immediately lowers the cuff pressure automatically.

6.6. Memory – storage and recall of the measurements

This blood pressure monitor automatically stores each of the last 30 measurement

values. By pressing the MEMORY button,the last measurement ( MR 01) as well

as the last 29 measurements ( MR 02, MR 03, ..., MR 30) can be displayed, one

after the other. Continue to press the Memory button to see other stored measure-

ments.

Understanding memory rea dings

0.5~1.0 cm

(1/4”~1/2”)

START/STOP

Time

Systolic

Diastolic

Pulse

START/STOP

Dec. 5 Time

(8:15)

(8:16)

Systolic

Diastolic

Pulse

MR 02

( MR 01: Values of the last measurement) ( MR 02- MR 30: Values of the

(Alternating display) measurements before MR 01)

DATE

TIME A.M.

DATE

TIME