User`s manual

5.9. Setting the Medication Reminder (6023 only)
This instrument allows you to set two alarm times at which an alarm signal will then be triggered. This
can be a useful aid, for instance as a reminder to take medication or to remind you to take your blood
pressure at the same time each day.
a) To set an alarm time, press the Date/Time button (the instrument must have been switched
off beforehand) and immediately afterwards the Memory button and hold both down until
the bell symbol appears in the bottom left of the display. Then release both buttons. The
flashing "1" in the display indicates that the first alarm time can now be set.
b) Press the Date/Time button to set the hour – the hour display flashes. Pressing the
Memory button allows you to set the alarm hour. To confirm, press the
Date/Time button
c) The minute display will now flash. The minutes can be set using the Mem-
ory button. To confirm, press the Date/Time button again.
d) The bell symbol will now flash. Use the Memory button to select whether
the alarm time is to be active (bell) or inactive (crossed-out bell). To con-
firm, press the Date/Time button.
To set a second alarm time, proceed as above but if the "1" flashes, press the
Memory button to select "2" and confirm with the Date/Time button.
An active alarm time is indicated by the bell symbol in the display.•
The alarm sounds at the set time every day.•
To switch-off the alarm when it is sounding, press the START/ON/OFF button.•
To permanently switch-off the alarm, proceed as above (Steps a-d)•
and select the crossed-out bell symbol. This will then disappear from
the display.
The alarm times must be re-entered each time the batteries are replaced.•
5.10. Battery Charge Indicator
Batteries almost discharged
When the batteries are approximately 75% used the battery symbol will flash as
soon as the instrument is switched on (if at least one of the batteries still has some
charge). Although the instrument will continue to measure reliably, you should obtain
replacement batteries.
Batteries discharged– replacements required
When the batteries are discharged, the battery symbol will flash as soon as the instrument
is switched on. You cannot take any further measurements and must replace the batteries.
The battery compartment is located on the back side of the device
(see illustration).
a) Remove cover from the bottom plate, as illustrated.
b) Insert the batteries (4 x size AA ). Always use AA long life bat-
teries or alkaline 1.5v batteries.
c) The memory retains all values although date and time (and
possibly also set alarm times) must be reset - the year number there-
fore flashes automatically after the batteries are replaced.
d) To set date and time, follow the procedure described in Section 4.2.
TIME PM