User`s manual

Each Model has its own specific cuff:
Model Item Number Description
6021 850-6013 D-bar Nylon Cuff
For arm circumference 22 - 32 cm or (8.7” - 12.6”)
6022 850-6022 Wide Range Soft Cuff
For arm circumference 22 - 41 cm or (8.7” - 16”)
6023 850-6023 Wide Range Rigid Cuff
For arm circumference 22 - 46 cm or (8.7” - 18.1”)
* If you ever need to buy a replacement cuff, use only ADC® brand.
Note: Arm circumference should be measured with a measuring tape in the middle of the relaxed
upper arm. Do not force cuff connection into the opening. Make sure the cuff connection is not
pushed into the AC adapter port. If the cuff is too small, call 1-800-232-2670 for further information.
You may prefer to use one of our wrist type monitors.
4. Using your Monitor for the First Time
4.1 Activating the pre-installed batteries
Pull out the protective strips projecting from the battery compartment.
4.2 Setting the date and time
a) After the new batteries are activated, the year number flashes in the
display. You can advance the year by pressing the Memory button. To con-
firm and set the year, press the Time/Date button.
b) You can now set the month using the Memory button. To confirm
and set the month, press the Time/Date button.
c) Follow the instructions above to set the day, hour and minutes.
d) Once you have set the last minute and pressed the Time/Date button,
the date and time are set and the time is continously displayed.
e) If you want to change the date and time, press and hold the
Time/Date button down for approx. 3 seconds, release, then hold again for
another 3 seconds, and release - the year number will then flash. Now you
can enter the new values as described above.
4.3. Cuff tube connection
Insert the cuff tube into the opening on the left side of the monitor indi-
cated by the drawing of a cuff.
4.4. Select the Measuring Mode: Standard or
ADC® Averaging Mode Technology™ (6022,
6023 models only)
This instrument enables you to select either
standard (standard single measurement) or ADC®
Averaging Mode Technology™ (automatic triple
measurement). To select standard mode, push the
switch on the side of the instrument downward to
TIME PM
Memory But-
ton
Time/Date
Button