Service manual

G. Lint Coop

The lint coop is the bottom portion of the dryer behind

the lint door. Inside the lint coop is the lint screen

which prevents lint from entering the exhaust system.

The lint screen should be kept clean at all times. On

AD-15 and AD-25 models there are two (2) lint screens.

The lint screens should be cleaned on a daily basis.

Lint screens with tears or holes should be replaced

immediately.

H. Tumbler

The tumbler consists of three or four ribs and a

perforated basket along with a front and back which are

riveted or screwed together as an assembly. The

tumbler also consists of tie rods which support the

tumbler from front to back. The tumbler support is

used to mate the tumbler to the drive system in the rear.

Some models also have a felt band which helps to keep

lint from accumulating behind the basket.

I. Tumbler Bearing and Pulley

Arrangement

The tumbler bearing and the pulley arrangement is

located (viewing from the rear of the dryer)

approximately at the upper center of the dryer. The

arrangement consists of a pulley, bearing box, and

bearing which serve to adjust, drive, and support the

tumbler. The AD-15 and AD-25 have a different bearing

than illustrated but serve the same purpose. The

bearing box has various nuts and bolts that are made to

adjust the basket vertically and horizontally.