Service manual

TO ADJUST SAIL SWITCH

1. Operate the installed dryer normally to verify that the heat system is fully operational.

2. Open the main dryer door.

3. Manually depress the door switch actuator.

4. While continuing to depress the door switch actuator, and with the door open, start the dryer.

5. If the heat system is not activated in 15 seconds, the sail switch is properly adjusted.

6. If the heat system is activated, the sail switch is improperly adjusted and must be readjusted by bending the

actuator arm of the sail switch torward the front of the dryer. If the actuator arm is bent too far torward the

front of the dryer, the dryer may not have heat when needed. After any adjustments of the sail switch, the

above procedure must be repeated to verify proper operation.

CAUTION: Do not disable this switch by taping or screwing sail switch damper to burner.

Personal injury or fire could result.

H. FRONT PANEL and MAIN DOOR ASSEMBLIES

TO REPLACE MAIN DOOR SWITCH (ES)

1. Discontinue power to dryer.

2. Open main door.

3. Remove the two (2) phillips head screws holding the

main door switch in place.

4. Remove door switch bracket and disconnect wiring

from switch (es).

NOTE: Identify location of each wire for correct reinstallation.

5. Disassemble door switch bracket by removing the two (2) screws holding the door switch (es) in place and

assemble onto new door switch (es).

6. Reverse this procedure for installing new door switch (es).

NOTE: When reconnecting wires to door switch (es), be sure wiring sequence is correct.

IMPORTANT: Under no circumstances should the door switch be disabled.