Service manual

6. Remove the screws securing the front panel to the dryer.

7. Gently remove front panel assembly from dryer.

IMPORTANT: When removing front panel assembly be careful not to damage main door switch

wires disconnected in step 2.

8. Reverse this procedure for installing new front panel.

TO REPLACE MAIN DOOR HINGE

1. Discontinue power to dryer.

2. Follow procedure for removal of main door assembly.

3. Follow procedure for removal of front panel assembly.

4. Disassemble hinge from front panel by removing the nuts located on the back side of the front panel,

which hold the hinge to the front panel.

IMPORTANT: When removing hinge assembly from front panel be careful you do not damage

main door switch wires.

5. Remove main door switch assembly.

6. Re-assemble by reversing removal procedure.

NOTE: When connecting wires to door switch, be sure wiring sequence is correct.

TO REPLACE THE NYLON CATCH

1. Open main door.

2. Drill out two (2) pop rivots (P/N 154215) install nylon catch (P/N 170330) to front panel.