Service manual

42
J. IDLER AND BEARING ASSEMBLY
(Remove backguard to access assembly.)
TO REPLACE IDLER PULLEY
1. Remove backguard.
2. Loosen v-belts, then rotate pulley and roll v-belts
out of grooves.
3. Loosen the two (2) set screws on the pulley and pull
off the shaft.
4. Reverse procedure for installing new idler pulley.
NOTE: Check tension and alignment of belts before operating dryer.
TO REPLACE IDLER BEARING
1. Remove idler pulley (follow “TO REPLACE IDLER PULLEY”).
2. Remove idler arm.
A. Remove two (2) bolts securing idler arm to the idler backup plate.
B. Remove idler arm assembly.
C. Loosen set screws on both the front and rear bearing and remove the idler shaft.
D. Remove 3 bolts securing the bearing to the idler arm and remove bearings.
3. Reverse procedure for installing new idler bearings.
NOTE: Check tension and alignment of belts before operating dryer.