Service manual

E. NO DISPLAY CONDITIONS

1. Check power supply. (dryer voltage 110v, 208v, 220v ...)

2. Check for voltage across (L1) and (L2) of motor relay.

(110v, 208v, 220v ...) For 3 phase machines, check

across (L1) and (L3). If no voltage is evident, problem

is bad wire(s) or termination from circuit breaker panel

to top of motor contactor.

3. Check the .5 amp fuse(s) in the control box. If dryer

is rated at 110v, 115v, or 120v there will only be one

fuse. Voltages of 208v, 220v will have two fuses. If

blown, replace with P/N: 136057

4. Check voltage across TB #8 and TB #6 (110v, 208v,

220v). If no voltage is evident, problem is bad wire or

termination from TB #8 and TB #6 to the L1 and L2

connection on the motor relay.

1Ø Motors

3Ø Motors