Service manual

62
F. “sSFL” DISPLAY CONDITION
When the display reads “dSFL” this condition indicates a fault in the microprocessor controllers heat circuit.
This circuit includes the microprocessor controller, microprocessor temperature sensor (located in lint com-
partment) and wires to and from these two (2) points.
1. Check to see if microprocessor controller has 1/8 amp
fuse on the board, if it does check with out ohm meter.
If no continuity replace with ADC P/N: 136048.
If fuse repeatedly burns out go to step 4.
2. Check for loose connection at the microprocessor
sensor bracket harness connector (located in lint
compartment), and the microprocessor 15 position
connector at the microprocessor controller.
3. Discontinue power to dryer. Disconnect the
microprocessor 15 position connector from
microprocessor controller and locate connector
holes no. 10 and 15. Disconnect sensor harness
from sensor bracket assembly (located in the lint
compartment). Check for continuity across each
wire from harness connector in lint compartment
to appropriate microprocessor 15 position connector
hole (10 and 15). If no continuity, problem is break in
wire or termination.