Clothes Dryer User Manual

TO REMOVE THE TEMPERATURE SENSOR OR HIGH HEAT PROTECTOR

1. High Heat Protector

a. Discontinue power to dryer.

b. Remove the lint drawer from the dryer.

c. Remove the two (2) free spin wash nuts that is securing the temperature sensor bracket to the dryer.

d. Disconnect the 4-pin connector on the temperature sensor bracket.

NOTE: Be careful not to let the sensor harness that you just disconnected to fall back into the

computer area.

e. Remove the two (2) nuts, washers, and screws

securing the 190° hi-limit to the sensor bracket. Also

disconnect the two (2) connectors on the 225° hi-limit.

f. Reverse the procedure for installation of new high

heat protector.

2. Temperature Sensor

a. Discontinue power to the dryer.

b. Remove the lint drawer from the dryer.

c. Remove the two (2) free spin wash nuts that are

securing the temperature sensor bracket to the dryer.

d. Disconnect the 4-pin connector on the temperature sensor bracket.

NOTE: Be careful not to let the sensor harness that you just disconnected to fall back into the

computer area.

e. Remove the top tinnerman clip that secures the sensor probe to the bracket. Also remove the connector

from the bracket. Disconnect the two (2) wires going to the 225° hi-limit. The sensor probe assembly

can now be removed from the bracket.

f. Install new probe assembly (ADC PN: 880251) by reversing procedure.